Epson Stylus Pro 4400 - Cutter Assembly; Cutter Assembly Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 211
4.2.2.3 Cutter Assembly
1. Enter cutter replacement mode using the panel setting with printer power
on.
2. The carriage unit moves and stops at the cutter replacement position.
3. Open "Cover, Printer".
4. Press down on the "Cutter Assembly" tab and turn the "Holder, Solenoid"
in the clockwise direction. (Refer to Figure 4-9.)
5. Remove the "Cutter Assembly" from the "Carriage Unit".
(Refer to Figure 4-10.)
Figure 4-9. Cutter Assembly Removal_1
Figure 4-10. Cutter Assembly Removal_2
C A U T I O N
When pressing the "Cutter Assembly" tab in the following
steps, press it lightly because the cutter blade could scratch
the interior of the printer if it is pushed inward.
Tab
Holder, Solenoid
Cutter Assembly