Epson Stylus Pro 4400 - Screws Securing the Pump Cover; Pump Cover Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 323
4.2.8.8 Pump Phase Sensor
1. Remove "Pump Unit".
(Refer to "4.2.8.6 Box Assy., Flushing / Pump Unit" (p316).)
2. Remove the two screws securing the "Pump Cover".
(Refer to Figure 4-163.)
 C.B.P. 3x8: 2 pcs.
3. Remove the "Pump Cover" in the direction of the arrows.
(Refer to Figure 4-164.)
Figure 4-163. Screws Securing the Pump Cover
Figure 4-164. Pump Cover Removal
Pump Cover
C.B.P. 3x8
1
2