Epson Stylus Pro 4400 - Electrical Specification; Manual Cut for Roll Paper

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Product Description Basic Specifications 22
MANUAL CUT FOR ROLL PAPER
When using paper for which automatic cutting is prohibited, use manual cut
with the steps below.
1. Use [Paper Source / Paper Cut] button to select Roll Paper Auto Cut OFF
(" ").
2. Press and hold the [Paper Source / Paper Cut] button for 3 seconds.
3. The paper will be automatically fed to the manual cut position and the
printer will go offline, indicating “Pause”on the panel.
4. Cut off paper using own scissors.
5. Then press the [Pause] button and the paper will be fed back, and the
printer will be online.
NOTE 1: Auto cutter supports all genuine roll paper.
2: Paper of 3rd party media and generally auto cutter is prohibited.
• Fiber-form paper such as cloth.
• Rigidity is extremely high paper such as Vinyl (Outdoor type) or
Fine Art type.
1.2.8 Electrical Specification
 Rated voltage: AC 100 ~ 240V
 Input voltage range: AC 90 ~ 264V
 Rated frequency range: 50 ~ 60Hz
 Input frequency range: 49 ~ 61Hz
 Rated current: 100-240V ac, 50-60Hz, and 1.0-0.5A
 Power consumption
 operation status
• Stylus Pro 4400/4800: Less than 59 W
• Stylus Pro 4450/4880/4880C: Less than 55 W
 Less than 5 W for low power status (Shifting time: 15 minutes)
 Less than 1 W for Power OFF
 Insulation resistance: More than 10M ohms
(Between AC line and chassis is DC 500V)
 Dielectric strength: AC 1.0kV rms 1min. or AC1.2kV rms 1 sec.
(Between AC line and chassis)
 Leakage: Less than 0.25mA
[Adapts Japan National Electronics Development
Incorporated Association "Personal Computer
Industry Standard" (PC-11-1988)]
 Adapted standard regulation
Adapts International Star Program
(Adapts category: measure for harmonic
component suppression guideline)
Adapts VCCI class B