Epson Stylus Pro 4400 - Remaining Paper Display Setting; Unit Switching; Cutting Pressure; Panel Setting Initialization

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Product Description Operating Panel 87
PANEL DISPLAY LANGUAGE SELECTION
Users can select English, French, Italian, German, Spanish, and Portuguese
for display on the LCD with this mode.
REMAINING PAPER DISPLAY SETTING
This mode allows users to set the remaining paper detection to OFF/ roll paper
ON/ cut sheet ON. When the remaining paper detection is set to OFF, it is not
displayed in the printer setting menu. When the remaining paper detection is
set to roll paper ON/ cut sheet OFF, it is displayed.
NOTE: Roll paper and cut sheet cannot be set to ON simultaneously.
UNIT SWITCHING
Users can change length unit of LCD panel / pattern print with this mode.
 METER : meter (m)
 FEET/INCH: Feet (ft)/Inch (in)
Unit of following messages can be changed;
Note : This function is available only for English.
CUTTING PRESSURE
Changes cutting pressure, which is set in the printer.
Adjustment value (calculated by spring balance / input value) in the process is
set to 100% (printer default), input / setting range by the user is set to between
0% ~ 150%.
The value entered by this function is worked as absolute value of printer,
• Remote SN m1 = 81h
• Panel setting "User paper setting"
multiplied to the value specified above.
SUPERSONIC CLEANING (SSCL)
Users can execute supersonic cleaning using this mode. If the number of times
that this cleaning is performed exceedes 250 times
*
, however, the printer runs
CL3 instead.
Note *: This number will be reset by executing “Reset when printhead change“ after
replacing printhead.
PAPER FEED SETTING
This mode allows users to set a certain amount of paper not to be fed when
turning the printer on with cutter setting OFF, and this reduces waste of paper.
NOTE: When paper feed setting is set to on, the image will be printed on
the platen. Users have to change the setting at their own
responsibility.
PANEL SETTING INITIALIZATION
Users can change all setting values of panel setting mode to the default values
or the factory setting values.
 Printer Setting Menu :Turns default setting back
 User Paper Setting :Deletes the setting record
 Gap Adjustment Menu :Turns default setting back
 Maintenance Menu :Date setting is set back to absolute time
controlled by RTC power
 Printer Status Menu :Deletes all information
Table 1-37. Swithable Messages
Item
Message
Meter Feet/Inch
Panel LCD display Paper counter xxm xxft
Remainig paper menu xx.xm xxxft
Job information display (Paper
used)
xxxxx.xcm xxxxft xxin
Nozzle check
pattern
Job information display (Paper
used)
xxxxxxxcm
2
xxxxxx.xsqft
Current Paper Count xxxxx.xcm xxxxft xxin
Prev Paper Count xxxxx.xcm xxxxft xxin
Status sheet
Job information
print
Use Paper xxxxxx.xcm xxxxft xxin
Paper Used (vertical) xxxxxx.xcm xxxxft xxin