Epson Stylus Pro 4400 - Paper Width Detection; Level Structure for Detect Paper Width Menu

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Product Description Operating Panel 53
NOTE 1: The top margin is also set with "Set the paper top margin" (SN
command). Actual top margin is decided as following;
• Panel setup value (top margin) > Paper top margin
(Panel setup value is used as the top margin)
• Panel setup value (top margin) < Paper top margin
(Paper top margin is used as the top margin)
2: Under special condition (Right/left no margin print), right / left
margin can be set to 0.
3: When following pattern is printed, right and left side margin are
fixed to 3mm.
1.4.4.9 Paper Width Detection
When paper width detection is set to OFF or prints bigger image than set paper
(more than borderless print area), the image will be printed on the platen.
Users have to change the setting at their own responsibility.
When paper initializing or print starting, for distance between grid roller and #1
nozzle, paper is fed unconditionally. The print starts from the position. (No
back-feed with other sequences) Although the paper that is under grid roller will
be wasteful, place emphasis on printing even for low reflection paper.
Cut sheets and auto loading have same specification.
The above paper width detection OFF sequence is just for the first page in
case of roll paper.
Paper auto cutting is not checked whether it cuts off or not.
 Level structure for detect paper width menu
Print Pattern Menu Command
Nozzle Check Pattern Test Printing Menu NC Command
Auto Nozzle Check Pattern
Status Print SS Command
Job Information Print
User Paper Print
Paper Thickness Detection Pattern User Paper Setting Menu
Cutter Position Adjustment PRINTER SETUP ---
Auto Nozzle Check for each job ---
Manual Uni-D GAP Adjustment Menu DT/DC Command
Manual Bi-D K
Manual Bi-D
F/W ROM Version Print VI Command
[∧ / ∨]
[< / >]
[<]
PRINTER SETUP
PPR SIZE CHK
PPR SIZE CHK
ON
PPR SIZE CHK
OFF
[∧ / ∨]