Epson Stylus Pro 4400 - Harness Head Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 333
10. Peel off the three pieces of acetate tape that bundle the FFCs, then
remove the "Harness, Head, C". (Refer to Figure 4-179.)
11. Release the "Harness, Head" from the "Printhead".
(Refer to "4.2.8.1 Printhead" (p285).)
12. Draw out the "Harness, Head"s from the "Carriage Unit".
(Refer to Figure 4-180.)
Figure 4-179. FFC Release
Figure 4-180. Harness Head Removal
Acetate Tapes
Carriage Unit