Epson Stylus Pro 4400 - Panel Unit;Housing Removal; Holder, Roller, Unit; Screws Securing Holder, Roller, Unit; Holder, Roller, Unit Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 214
4.2.3 Panel Unit/Housing Removal
This section describes steps for removing housing parts.
4.2.3.1 Holder, Roller, Unit
1. Remove "Spindle" (p213).
2. Remove the four decorative screws securing the "Holder, Roller, Unit" to
the main unit. (Refer to Figure 4-14.)
 Decorative screw: 4 pcs.
3. Slide the "Holder, Roller, Unit" upward from the printer rear surface and
remove it outward. (Refer to Figure 4-15.)
Figure 4-14. Screws Securing Holder, Roller, Unit
Figure 4-15. Holder, Roller, Unit Removal
Screws
Holder, Roller, Unit