Epson Stylus Pro 4400 - Combination Gear; Intermittent Gear, Release, Transmit

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Maintenance Lubrication 453
Figure 6-7. INTERMITTENT GEAR
Figure 6-8. Intermittent Gear, Release, Transmit
Figure 6-9. Combination Gear, 36.8.8
Figure 6-10. Combination Gear, 12.22.4
• Lubrication Point
Cam part of "INTERMITTENT GEAR,
40"
• Lubrication Type
G-26
• Lubrication Amount
Φ1mm x approximately 7mm
• Remarks
Use a syringe/needle (JIS 17# or
equivalent) for application.
• Lubrication Point
Cam part and gear parts (3 teeth) of
"Intermittent Gear, Release, Transmit"
and inner surface of bush (1 place)
• Lubrication Type
G-26
• Lubrication Amount
1. Φ1mm x approximately 5mm
2. Φ1mm x approximately 7mm
3. Φ1mm x approximately 1mm
(Applies from the outside of the
frame.)
•Remarks
Use a syringe/needle (JIS 17# or
equivalent) for application.
2
1
3
• Lubrication Point
E shaft of "Frame, Sub, Right" and
pinion gear part of "Motor Assy., PG"
• Lubrication Type
G-26
• Lubrication Amount
1. Φ1mm x 5mm (approximately 1mm
inside from groove for E shaft-ring)
2. Φ1mm x half circumference or
Φ2mm x quarter circumference
• Remarks
Use a syringe/needle (JIS 17# or
equivalent) for application.
• Lubrication Point
Shaft of "Combination Gear, 12.22.4"
• Lubrication Type
G-26
• Lubrication Amount
Φ1mm x 15mm
• Remarks
Use a syringe/needle (JIS 17# or
equivalent) for application.
1
2
E shaft
Frame, Sub,
Right