Epson Stylus Pro 4400 - Holder, FFC, CR Removal; Harness, Head, C Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 332
6. Remove the five "Holder, FFC" ("Holder, FFC; B").
(Refer to p325 and , p328.)
7. Remove the "Carriage Cover".
(Refer to "4.2.4.3 C593_SUB Board" (p234).)
8. While releasing the upper tab of the "Holeder, FFC, CR" ( ), slide the
"Holeder, FFC, CR" frontward to remove it ( ). (Refer to Figure 4-177.)
9. Disconnect the "Harness, Head, C" from the connector on the "C593_SUB
Board". (Refer to Figure 4-177.)
Figure 4-177. Holder, FFC, CR Removal
Figure 4-178. Harness, Head, C Removal
When reassembling the "Holder, FFC, CR", match the
dowels with the positioning holes of the "Carriage Unit" and
install the "Holder, FFC, CR", then secure it with the tab.
Dowels
Positioning Holes
1
2
Tab
C593_SUB Board