EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Product Description Basic Specifications 20
1.2.7.2 Borderless Print Specification
By driver's command transmission, supports the following borderless print
mode. Supports the following 3 modes.
Note 1: For 4 sides borderless, after cutting, up and down size of the printing will be
smaller by approximately 2mm than the actual printing size.
2: When the roll paper cutter is OFF and page line printing is ON, print the page
line at each cutting position including front edge page.
3: In following media, if 1 cut is selected at borderless printing, it is cut as 2 cut to
prevent scraping top of paper.
• Premium Glossy Photo Paper
• Premium Semigloss Photo Paper
Note *: Recommended a borderless length for glossy paper is 60mm, for other paper
is 100mm.
Borderless setting method
Table 1-13. Borderless Print Specification mode
Mode Operation
Right and left
borderless (default)
You can set only the right and left margins to zero. At this time,
up and down margins are set by roll paper margin setting.
4 sides borderless/1 cut You can set 4 sides margins to zero. Use the following
method for cutting.
Starting of JOB, take minimum cut length for margin and
cut while printing.
While JOB, new page has no margin, cut at image border
position in continuing print.
End of JOB, cut at the bottom of the image.
4 sides borderless/2 cut You can set 4 sides margins to zero. Use the following
method for cutting.
At the front edge page, take refresh margin length for
margin, cut while printing.
At the end of the page, cut at the bottom of the image.
To discard the remaining part of printing after cut, cut the
paper after advancing the paper to minimum cut length.
*
Table 1-14. Borderless setting
Borderless mode
Right and left
borderless
4 sides borderless
(1 cut)
4 sides borderless
(2 cut)
Printer operation
Driver setting Borderless print Borderless print
Single cut
Borderless print
Double cut
Note Default setting
The upper edge
cut is performed
by interrupting
print operation;
there is chance of
color shading
according to data.
By adjusting
cutter position,
there is chance of
data from
continuous page
remaining in top
or bottom edge of
the page.
The upper edge
cut is performed
by interrupting
print operation;
there is chance of
color shading
according to data.
To avoid
remaining of
margin, cut off the
top and bottom
part of the paper
by going inside of
image.
Therefore the
actual size will be
about 2mm
smaller than the
specified print
area.
To Next Page
Loading...
