Epson Stylus Pro 4400 - Page 261

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 261
Install "Mount Assy., Plate, Motor, ASF, SP" following the
steps below.
1. "Combination Gear 12, 22.4" may fall from the "Mount
Assy., Plate, Motor, ASF, SP" when removing it. If this
happens, properly install the gear as shown below.
2. Install "Mount Assy., Plate, Motor, ASF, SP" in a way that
avoids interference between "Combination Gear 12,
22.4" and "Spur Gear, 18".
Combination Gear 12, 22.4
Spur Gear, 18
Location of Interference
3. Insert shaft of frame while aligning it with installation
hole of "Mount Assy., Plate, Motor, ASF, SP".
4. Confirm that "Spur Gear, 19.2" and "Combination Gear
13.6, 28.8" are engaged.
Shaft
Installation Hole
Combination Gear 13.6, 28.8
Spur Gear, 19.2
Gear Engagement
Location