evertz 3025SW - Page 192

3025SW Master Control Switching & Channel Branding
Page 178 Revision 1.0
Wipe Special
Mid Wipe Point, Wipe
Mode, Run Wipe Mode
Configure the wipe
special settings.
N/A
DVE Level
Normal/Primary DVE or
Secondary DVE
Set the level of the DVE.
Transitional on or off air.
N/A
DVE On-Air
Normal/Primary DVE or
Secondary DVE
Set the on-air state of the
DVE.
N/A
DVE Move Normal
Primary
Move Number (1 to 63)
Select a Primary DVE
move by number. Where
this Primary move is in
the DVE Table.
Note: When a move is
selected any crosspoint
changes configured in
the move will take place
immediately when the
move is selected.