EXFO MaxTester 635G - Technical Specifications

Introducing the MAX-635G
Copper and G.fast/VDSL2/ADSL2+ Multi-play Test Set 9
Technical Specifications
that uses the first pair (pins 3-4), use the red cable (pair 2) of the provided
ACC-BD-RJ test cable, RJ14 to dual RJ-11, and an RJ11 female adapter
ACC-RJ11-ADPTR.
Technical Specifications
To obtain this product’s technical specifications, visit the EXFO Web site at
www.exfo.com.
WARNING
A 50 to 500 Vcc limited power source may be present on connector
T/R/G (A/B/E), T1/R1/G (A1/B1/E) when the unit is testing isolation
resistance. Use with caution.
WARNING
These connections are intended for the express purpose of electrical
testing of common telephone line conductors, within the ranges
specified in the Technical Specifications found on the EXFO Web
site. The device is not intended to be used on telephone lines
having voltages greater than 280 VAC or 400 VDC, and it is also not
intended to be used on power distribution circuits.
CAUTION
The unit is protected against damage caused by fault voltages that
may be present on lines under test. Do not connect the unit if the
maximum expected fault voltage is greater than 500 volts.