Running DSL/IP Tests and Viewing Results
376 MAX-635G
WAN Status
WAN IPv6 parameter replaces the IPv4 Assigned IP, when IPv6
(DHCP) is set as the Access Mode in Connection Setup, because
there are 2 assigned IPv6 addresses: the global one (WAN) and the
local one (Link-Local).
Link-Local IPv6 is only displayed when IPv6 (DHCP) is set as the
Access Mode, and is the assigned local IPv6 address.
Gateway is the IP address of the default gateway.
Subnet Mask is the network address used to identify if the IP address is
within the same WAN.
DNS1 is the address of the primary domain name server to be used by
the unit.
DNS2 is the address of the secondary domain name server to be used
by the unit.
VPI (ATM mode only) is the virtual path identifier value, not available
in PTM mode.
VCI (ATM mode only) is the virtual circuit identifier value, not available
in PTM mode.
VLAN ID is a virtual local area network (VLAN) tag ranging from
0 through 4094. The entry is available only when VLAN Support is
Enable.
Test (for Manual Test only) allows you to select which triple play test
you want to run or results to view, along with their respective tabs:
Data Test - LAN Status and Data Tests Summary.
IPTV Test - Join Leave and IPTV Summary.
VoIP Test - VoIP Call and VoIP Summary.
The WAN info reflects the state of currently selected test.
To Next Page
Loading...
