Festo SPC200 - Page 202

5. Programming
5−16
Festo P.BE−SPC200−WIN−PISA−CD−EN en 0901d
Processing the position list
Do not use any special characters or reserved command
words when entering the symbolic identifier.
Editing the position list To edit a field in the position list:
1. Move the selection (the frame) to the field you want to
modify.
2. Press ENTER. The field will now be in edit mode
(seestatus bar).
3. Enter
the desired value in the field.
4. Confirm the entry with ENTER. The edit mode will be
exited when a permitted entry is made.
Save modifications to the position list by selecting [Save]
from the [File] menu or by clicking on the Save active win
dow" button in the toolbar when the position list
window is
active.
Use the decimal point as divider (e.g. 300.05) for entries in
the position list.
Enter maximum 2 decimal positions.