Festo SPC200 - Page 331

6. Diagnostics and optimization
6−27
Festo P.BE−SPC200−WIN−PISA−CD−EN en 0901d
7. Accept the new axis position into the position list with
Enter". The position is entered after the axis identifier
next to Position Register"
8. If you wish to ascertain a relative position, move to a
starting position and activate the check box Relative"
under Position register". The position display under
Procedure" will be reset to
the value 0.00" and in
further movements of the axis will show the position rela
tive to the start position.
9. Repeat steps 4 to 6 if you wish to optimize further posi
tions.
10. Close the dialogue window Optimize position" with
Exit".