1. Installation and general user information
1−36
Festo P.BE−SPC200−WIN−PISA−CD−EN en 0901d
Data transmission errors
The following error message will appear if there are problems
with data transmission:
Fig.1/19: Data transmission errors
First check the cable connection (plug, damage to cable). If
no fault can be seen here, then it is possible that data trans
mission cannot take place at the baud rate specified. This
may be because of the PC interface card or unfavourable
environmental conditions.
In this case, you should reduce
the baud rate until Online
mode can be activated.
To Next Page
Loading...
