Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
100
This solution requires that the flexible fixture hanger is drilled out slightly so that the RJ-45 connectors
(Ethernet connector) will fit through. This solution works especially well on ceilings with slope due to
the flexible functionality of the hanger. However, once the 3D Gen 2 is installed, it is critical that a set
screw be added into the ball of the hanger to prevent any further movement, as shown in the following
image:
Note: This set screw should be applied in all circumstances
including straight down installations to prevent movement.
To Next Page
Loading...
