FLIR BRICKSTREAM 3D Gen 2 - Enabling Wi-Fi;Ble Features (2510 Model Only)

Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
91
Enabling Wi-Fi/BLE Features (2510 model only)
If using Wi-Fi or BLE features on the 3DGen 2 2510 model, you must insert the dongle into the USB
port. This can be done before or after installation.
The USB port is on the side of the 2510 model as
shown.
Remove the tab with a tool. To prevent theft, the
USB Wi-Fi BLEdongle is designed to be difficult to
remove. If necessary to remove the dongle use a
tool as shown.
Insert the USB Wi-Fi BLE dongle into the tab.
Ensure the dongle is the right side up to fit into the
port.
Insert the tab back into the sensor.
The tab can only be inserted if the notches align
with the case as shown.
Reboot, or power up the sensor.
Once inserted, the presence of the USBdevice appears on the sensor's home page.