Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
13
Planning the Solution Design
Using the 3D Gen 2 sensor requires following the instructions in this document to set up the sensor for
communication, install the sensor, and then configure the supporting software. The following section
provides guidelines, considerations, and procedures to ensure optimal planning of the solution design
for your site. Detailed procedures for creating the zones to deliver the desired metrics are provided in
the 3D Gen 2 sensor configuration guides.
When planning the solution for a site, follow this process:
1. Selecting the Appropriate Lenses
2. Performing a Site Survey
3. Determining How Many Sensors You Need
4. Determining Installation Locations
To Next Page
Loading...
