FLIR BRICKSTREAM 3D Gen 2 - Using a LAN

Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
55
Note: Wi-Fi is available for sensors equipped with a USB Wi-Fi
BLE dongle and Wi-Fi license. Check the Home page to verify the
dongle is active. Connection to a Power over Ethernet (PoE)
device is still required to power the sensor but a LANconnection
is not required.
Using a LAN
1. On the Settings>Basic Settings page, if not already there, click the IPSettings tab.
2. The Host Name field is prepopulated with Cam-<sensor serial number>.
3. If your network uses DHCP, click the DHCPswitch to ON. You do not need to enter any further
information.
Note: Even if your network is DHCP enabled, be sure to
work with your network administrator to reserve a range
of IP addresses for sensors at this location before
choosing to use DHCP with the sensors.
Note: Path linking is not supported on sensors that use a
DHCPserver for their IPaddresses.
4. If your network does not use DHCP, click the switch to OFF and enter the following information:
n Sensor IPAddress
n Network Mask
n Default Gateway
n DNSServer
5. Click Save.