FLIR BRICKSTREAM 3D Gen 2 - Lens Coverage; About Coverage Widths

Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
17
4. In the Inputs area:
a. Select a Lens (mm).
b. Enter the installation Height (meters).
c. Enter a digital zoom level. If no zoom level is needed for your mounting height, select No
Zoom.
d. If the sensor is tilted, enter the degree of tilt in X Tilt (degrees) or Y Tilt (degrees).
e. If there are walls on any side of the sensor coverage area, select yes for Side Walls.
The calculations for average, maximum, and minimum widths and heights are calculated dynamically
based on your inputs and display in the coverage area’s columns.
Lens Coverage
The following tables provide the coverage measurements based upon the installation height for each 3D
Gen 2 stereo lens.
Note: All measurements are in meters, except for lens sizes
which are in millimeters (mm).
About Coverage Widths
The coverage widths shown in the following tables include an extra meter from the coverage widths
shown by default on the Coverage tab in the Coverage Calculator spreadsheet. This increased coverage
assumes that there are walls bordering each side of the coverage width. Having walls on each side of