Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
9
The 2510 model has access for USB Wi-Fi BLEdongle on the side
Software (Firmware) Components
Note: The terms software and firmware are used interchangeably
to refer to programming on the sensor.
The Brickstream sensor is loaded with the available software prior to being shipped to a customer. It
may be necessary to update the software before installing the sensor. The factory default configurations
are present on the sensor.
The sensor includes a web interface that can be accessed from any standard web browser that can
access the network where the sensor is connected. The web interface provides configuration
capabilities for the sensor.
Note: The sensor's firmware version is in the footer of the sensor
web interface.
An update to firmware may include a separate package to update drivers used by the sensor. See the
sensor's Configuration Guide for steps on Upgrading Firmware.
Licensing
With the basic license, the 3D Gen 2 sensor includes:
n 1 count zone
n Tilt up to 10°
n Privacy
n Data encryption
With an advanced counting key license the sensor has access to the following features:
n Advanced counting up to 32 zones
n Tilt greater than 10°
To Next Page
Loading...
