Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
94
identifying:
n Types of sensors required to meet the coverage needs for the areas of interest.
n Size of lenses required for each area of interest, based on ceiling height, clearance, and
other considerations, such as those described in Mounting a 3D Gen 2 Sensor
n The number of sensors required to adequately cover all areas of interest.
n Installation positions, as defined by at least two measurements from permanent fixtures in
the coverage area, such as walls.
n Installation mounts that are needed.
2. Use dimensions shown in the design drawings to locate the installation position for each sensor.
Warning!
Sensors are available in multiple lens types, with the
desired lens size and type determined by the ceiling height
at each installation location. This means the sensors are
NOT interchangeable and must be installed at the location
specified on the design documents. The labels on the
boxes reference the specific location in the design
drawings at which each sensor should be installed,
typically using SD-xx to identify each sensor, where xx is
the sensor # in the design.
3. Verify that there are no obstructions preventing mounting in the desired location, as described in
detail in Mounting a 3D Gen 2 Sensor.
4. Run the CAT5e cable from the PoE source to each installation position.
5. Unpack mounting hardware.
6. Carefully unpack the sensors and inspect for physical damage prior to installation.
Warning! Do not touch or press on any of the lenses,
because any fingerprint or the slightest shift in orientation
can compromise calibration, resulting in inaccurate
tracking.
7. For each surface mount, perform Installing a Surface Mount.
Installing a Surface Mount
A drilling template for surface mounts is available from your FLIR representative.
To Next Page
Loading...
