Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
63
Manual Time Setup
Note: This is a one-time setting when time synchronization is
not used. Manual time setup is subject to time drift.
1. In the Date field, enter the current date.
2. In the Time field, enter the current time.
3. Click Set Time.
Setting the Delivery Address for Logging
To receive and archive logs and alert messages, you must have an application running on the server
that parses the XML files and writes them to a database or a log file.
1. On the Settings>Basic Settings page, click the Logging tab.
2. Click the Enabled switch to ON. The fields become active.
3. In the IP or Host Name field, enter the IP address of the server to receive data from the sensor.
4. In the Port Number field, enter the port number to which the sensor should attempt to deliver
XML log and diagnostic data.
5. In the Destination URL/directory field, enter the URL if the sensor needs to send data to a specific
URL in the HTTP POST. Set it to / if you have not been directed to change this field
Note: This feature allows your IT department to use the
same port for multiple sensors and filter the traffic by the
URL in the HTTP POST.
6. In the APIToken field, enter the API token. An API token is a cryptic string of up to 255
characters, used to authenticate access to the HTTPS server.
To Next Page
Loading...
