Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
99
3. Attach the 3D Gen 2 to the mounting bracket.
Note: The mounting bracket used to attach the
Brickstream sensor to the installed pole will be provided
by Brickstream along with the 3D Gen 2.
Ordering information: RAM STRAP BASE WITH 1/4”-20
STUD
Part Number: RAM-B-108U-BIT1
4. Attach and secure the mounting bracket to the pole.
5. Connect the CAT5e cable to the 3D Gen 2.
6. Carefully remove protective lens caps on the sensor, being careful not to touch the surface of the
lens.
Recommendations
A sample mounting solution that has been used to install the 3D Gen 2 in an open ceiling environment
is shown here:
To Next Page
Loading...
