Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
108
3D Gen 2 Sensor Specifications
This section provides the following specifications for the 3D Gen 2 sensor:
n Network Requirements
n Average Bandwidth Requirements
n Logical Port Specifications
n Connectivity
n Technical Specifications
n Components
n Lenses
n LED Functionality
n Part Numbers
Network Requirements
The primary data format of the sensor is XML data packets containing various metrics such as
arrival/exit counts, queue lengths, wait times, and service times. No personally-identifiable information
is collected or transmitted.
Data Stream Purpose
Time synchronization stream To maintain accurate date and time
Diagnostics stream Transmitting messages and alerts
Sensor management stream Enterprise-level administration
On-demand remote video capture and transmission stream Accuracy validation
Average Bandwidth Requirements
Data Description
Frequency Average Bandwidth
Required
Use of Web-Based Configuration Utility Initial ~128 kbps
Transmission of Validation Video Initial ~128 kbps
a
Transmission of XML Data, Time Sync, Diagnostics, Sensor
Management
Ongoing ~0.25 kbps per sensor
b
Initial Bandwidth Requirements
Bandwidth requirements for the sensor are at their highest during and immediately following
installation. These heightened requirements are due to the need to access the sensor’s on-board
a
Assumes single-zone counting captured/delivered at 5-min/15-min intervals
b
Assumes 15-min time sync intervals, 15-min diagnostics intervals, and 30-sec proxy intervals
To Next Page
Loading...
