FLIR BRICKSTREAM 3D Gen 2 - Step 9 of 10-Data Delivery

Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
51
Step 9 of 10—Data Delivery
1. Click the Enabled switch to ON. The fields become active.
2. In the IP or Host Name field, enter the IP address of the server to receive data from the sensor.
3. Enter the Port Number to which the sensor should attempt to deliver data.
4. If the sensor needs to send data feeds to a specific URL address in the HTTP POST, in the
Destination URL/directory field, enter the URL address.
Note: Use ‘/’ if you have not been directed to change this
field. This allows your IT department to use the same port
for multiple sensors and filter the traffic by the URL in the
HTTP POST.
5. From the Aggregation Level list select how often to aggregate the count report in minutes (1, 5,
15, 30, or 60).
6. From the Delivery Schedule list choose how frequently to deliver the aggregated data sets
(Immediate - 1 minute, Immediate - aggregation, 15 minutes, 30 minutes, or 60 minutes). The
metric data is delivered at this interval and at the aggregation level you selected in the previous
step. The immediate selection randomizes the delivery time over a 1 minute window (Immediate
- 1 minute) or over the aggregation level window (Immediate - aggregation).
Note: The sensor delivers at a random frequency over the
selected interval in order to limit the number of concurrent
connections required on the server side.
7. In the APIToken field, enter the token. An API token is a cryptic string of up to 255 characters,
used to authenticate access to the HTTPS server.
8. If you want the batch data stream to be encrypted:
a. Click the Data Encryption switch to ON.
b. In the SNI Host Name field, enter the Server Name Indication (SNI) hostname or IP address
for the host.
9. Click Test Settings to confirm entries.
10. Click Save & Next.