Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
7
Introduction
Welcome to the Brickstream 3D Gen 2 sensor. The sensor represents the next generation of video
analytics. Brickstream 3D Gen 2 captures and analyzes traffic metrics in a single sensor for retail
outlets, malls, transportation hubs, and smart buildings.
The sensor technical documentation suite includes:
n Brickstream 3D Gen 2 Installation Guide (this document)
n Brickstream 3D Gen 2 Counting Configuration Guide
n Brickstream 3D Gen 2 Advanced Configuration Guide
n Brickstream Programmer’s Guide for developers
The FLIRBrickstream support website contains links to firmware and documentation as well as
technical notes.
Contact your FLIRBrickstream representative for more information.
About this Document
This Installation Guide details installation instructions for installers, implementation engineers, as well
as support teams and training coordinators.
What is Covered
This document is divided into the following sections to help you navigate the sensor:
Section Provides
Introduction
An overview of the sensor technology and an outline of the supporting
documentation that can be found in this guide.
Planning the Solution
Design
Steps to follow when planning a solution for a site, including selection of
lenses, performing a site survey, and creating a solution design.
Setting up the Sensor Instructions on how to use the PoE system; setup IP address client network
connection; and create basic configuration settings.
Installing the 3D Gen
2 Sensor On-Site
Instructions on how to mount and provide power to the sensor as well as how
to verify its operation using calibration.
3D Gen 2 Sensor
Specifications
Specifications of the sensor including: network requirements, technical
specifications, components, and part numbers.
Troubleshooting Troubleshooting and corrective actions.
To Next Page
Loading...
