FLIR BRICKSTREAM 3D Gen 2 - Step 4 of 10-Privacy Settings

Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
46
Step 4 of 10—Privacy Settings
Warning! After saving the privacy settings, removing the
privacy settings requires using the physical Reset button
on the sensor.
Privacy options allow you to prevent AVI captures from the sensor and to mask live video image
streams to prevent anyone from viewing images from the sensor.
1. Select the video overlay from the following options:
None (default) Edge Height
2. AVICapture is enabled by default. To disable, click the AVI Capture switch to OFF.
3. Click Save &Next.
Note: This information is also on the Settings->Basic Settings
Privacy page.