FLIR BRICKSTREAM 3D Gen 2 - Installing a Recessed Mount

Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
95
Note: For accurate size of the cutting template, the template must
be printed at 100% (no scaling) on legal (8.5 x 14”) paper. For
greater durability, choose a paper weight greater than 30 lbs.
The surface mount is an integrated bracket for installing 3D Gen 2 sensors externally.
Item Specification
Drilling hole diameter 5mm (0.195 inches)
Tilt 0 degrees
Hardware required
(not provided)
2 screws less than 5mm (0.195 inches) appropriate for surface to
which bracket will be attached
Installing a Recessed Mount
The following diagrams provide detailed information about the recessed mounts available for the 3D
Gen 2 sensor. A cutting template for recessed mounts is available from your FLIRBrickstream
representative.
Note: For accurate size of the cutting template, the template must
be printed at 100% (no scaling) on tabloid (11 x 17”) paper. For
greater durability, choose a paper weight greater than 30 lbs.
The 9-inch recessed mount is a custom-made bracket for installing 3D Gen 2 sensors. The following
diagrams provide measurements and installation reference for the 9-inch recessed mounts.