Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
96
Item
Specification
X-tilt Carriage
Recess depth 57mm (~2.25 inches)
Mounting hole diameter 231mm (~9.0 inches)
Visible diameter 267mm (~10.5 inches)
Tilt Up to 50 degrees
Hardware required 2 x ¼”-20 thread x 3/8' machine screws
Follow these steps to install a 3D Gen 2 recessed mount:
1. Remove from the ceiling the tile that is to be used for the mount location.
2. If the tile material requires reinforcing, apply backer board to the tile where the recessed mount
will be installed, trimming the backer board for exact fit.
3. Measure the distance from the edge of the tile to the center of the sensor location.
4. Use the Recessed Mount Cutting template included at the end of this document to ensure correct
size and shape for cutting the tile and backer board.
5. Cut through tile and backer board following the line drawn from the template.
6. Use twine or safety wire (as per local building standards and regulations) to secure the recessed
mount to a permanent structure inside the ceiling, such as a beam.
7. Carefully remove protective lens caps on the sensor, being careful not to touch the surface of the
lens.
8. Remove the carrier tray from the mount.
9. Carefully center the sensor in the mount.
10. Ensure that the LEDs are clearly visible through the small holes in the carrier.
11. Use the hardware provided in the zip-closure bag to secure the sensor in the carrier.
To Next Page
Loading...
