Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
88
n Installer-provided patch cables 3m to 4.6m (10–15ft) should connect biscuit mounts to sensors
installed on RAM mounts.
n All cables at both head end and sensor end of the home run should be tied to create a neat and
clean look for maintenance.
n All CAT5e cable runs must be fully tested and results provided on request.
Biscuit Mount
PoE Connection Options
The following table describes how to connect the 3D Gen 2 sensor to the network/PoE cables using one
of the following methods.
To Next Page
Loading...
