Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
3
Contents
Introduction 7
About this Document 7
What is Covered 7
About the Brickstream 3D Gen 2 Sensor 8
Hardware Components 8
Software (Firmware) Components 9
Licensing 9
Data Quality 10
Before You Begin 12
Planning the Solution Design 13
Selecting the Appropriate Lenses 14
Lens Coverage 17
About Coverage Widths 17
2.5 mm Lenses 19
6.0 mm Lenses 21
Performing a Site Survey 23
Preparing for a site survey 23
Types of mounts 23
Field Samples 25
Gathering Information During a Site Survey 26
Verify Site Accessibility 27
Creating the Solution Design 30
After the Site Survey 30
Determining How Many Sensors You Need 30
Determining Installation Locations 31
Determining Sensor Tracking Coverage Areas 31
Identifying the Optimal Installation Location 31
Verifying the Solution Design 34
Setting up the Sensor 35
Using the Web Interface 35
Browser Requirements 35
Accessing the Web Interface 35
Navigation 37
To Next Page
Loading...
