Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
79
18. To pass an IP address that differs from the sensor IP address to the firewall and FTP server:
a. Click the External IP switch to ON.
b. In the Override IP/Host Name field, enter an IP address.
19. Click Test Settings to confirm entries.
20. Click Save.
Note: If you encounter any error messages when setting the FTP
connections seeTroubleshooting FTP Connections.
Setting Wi-Fi Options
The sensor can track Wi-Fi sources and send this data to a server.
1. Open the web interface to the Data Delivery> Wi-Fi page.
2. Click the Wi-Fi Enabled switch to ON. When ON, the sensor enables its Wi-Fi antenna and tracks
Wi-Fi sources.
The fields become active.
3. In the IPor Host Name field, enter the IP address of the server to receive data from the sensor.
4. In the Server Port Number field, enter the port number to which the sensor should attempt to
deliver data.
To Next Page
Loading...
