FLIR BRICKSTREAM 3D Gen 2 - Page 78

Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
78
File Naming Convention Field Resulting File Name
#S_#I_#T Grocery_987_140000
countdata-#S-#I-#D#T.txt countdata-Grocery1-987-090226140000.txt
#T#D_#M.csv 140000090226_00-b0-9d-70-01-05.csv
7. In the Delivery area, from the Aggregation Level drop-down, select the level at which you want
the metric data to be stored in the files.
The sensor can store data in intervals of 5, 15, 30, and 60 minutes.
8. From the Delivery Format drop-down, select the format for the data files sent over FTP.
Format Option Description
Pipe Delimited
The Pipe Delimited format sends data for each report zone with the
relevant information separated by a pipe character ‘|’.
XML
The XML format sends metric data in an XML file similar to the XML
packets that are sent out using the Batch Data Streaming option. See the
Programmer's Guide for more information on the XML format.
9. From the Delivery Schedule drop-down, select the frequency at which the FTP file is sent. You
can have an FTP file delivered each hour, or you can have the file delivered once daily at a
scheduled time.
10. If you selected daily delivery in the previous step, in the Delivery Time field enter a delivery time,
using 24-hour notation. (Note: if aggregation is set to 60 minutes, the delivery time should be set
to after midnight.)
11. In the Max Attempts field, enter the maximum number of times the sensor should attempt to
connect to the FTP server to send the files in the case of a failure.
Note: If this field is set to zero, the sensor continues to
retry indefinitely until it successfully sends the file.
12. In the Retry Interval field, enter the amount of time, in seconds, the sensor waits before
attempting to reconnect to the FTP server. This value can range from 1 to 599 seconds.
13. In the Authentication area, in the Username field, enter the FTP username used to log.
14. In the Password field, enter the password for this username.
15. In the Encryption area click the FTPS switch to ON to enable the encrypted FTPS protocol to
deliver the data.
16. If you are using a SSL Virtual Host and Server Name Identification, in the SNIHost Name field,
enter the host name.
17. To use active FTP with a limited port range that is used for connections:
a. In the Active FTP area click the Port Range switch to ON.
b. In the Lowest Port and Highest Port fields, enter the port range.