Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
56
Using Wi-Fi
1. On the Settings>Basic Settings page, click the Wi-Fi Settings tab.
2. Click the Enabled switch to ON. The fields become active.
3. If you are within range of the Wi-Fi network:
a. Click Select Network. The Visible Wi-Fi Networks dialog opens.
b. From the list, click your choice and click Select Network. (If the list does not contain your
Wi-Fi network, click Refresh.)
c. The SSID and Security Protocol are populated with your network selection.
4. If you are not in range of the Wi-Fi network:
a. In the SSID field, enter the ID for the network.
b. From the Security Protocol drop-down, select a protocol: Open, WEP, WPA, or WPA2.
5. If your protocol is Open, skip to Step 6, otherwise, enter the Password.
6. If your network uses DHCP, click the DHCPswitch to ON. You do not need to enter any further
information.
Note: Even if your network is DHCP enabled, be sure to
work with your network administrator to reserve a range
of IP addresses for sensors at this location before
choosing to use DHCP with the sensors.
To Next Page
Loading...
