FLIR BRICKSTREAM 3D Gen 2 - Step 10 of 10-Networking

Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
53
Step 10 of 10—Networking
The networking step allows you to set the IP address for the sensor or to use DHCP if your network has
a DHCP server. If using Wi-Fi, exit the wizard and go to the Settings->Basic Settings page, Wi-Fi tab.
Note: Saving changes to the networking settings automatically
reboots the sensor.
1. If using a DHCPserver, click the DHCP switch to ON.
2. If using a fixed IPaddress, click the DHCP switch to OFF and enter the following:
n Sensor IPAddress
n Network Mask
n Default Gateway
n DNS Server
3. Enter the HTTP/HTTPS settings:
n Host Name
n HTTPPort
n HTTPS Port
4. Click Save &Close.
Note: If you change the IP address on a sensor and save your
changes, you lose connectivity to the sensor for several seconds
while it is being enabled with the new IP address.