Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
35
Setting up the Sensor
Using the Brickstream sensor requires following the instructions in this book to preconfigure and install
the sensor, and then configure the supporting firmware. The following section provides you with step-
by-step instructions for configuring the sensor’s network connectivity, pointing it to the servers, and
setting the various options for delivering the data from the sensor.
Using the Web Interface
The Brickstream sensor includes the browser-based web interface, which allows you to configure and
manage the sensor directly. Be sure that your computer meets the following browser requirements so
that you can fully access the web interface.
Browser Requirements
The following browsers are compatible with the sensor web interface:
Platform Browsers Versions
Mac Safari Current
Windows
Internet Explorer 10.0 and newer
Mozilla Firefox 20.0 and newer
Google Chrome 55 and newer
Accessing the Web Interface
To access the web interface to preconfigure the sensor, use the default IP address of 192.168.1.7. All
sensors are shipped to customers with this default IP address. Refer to Setting the Network IP Address
for detailed instructions on how to change the default IP address to a client network IP address.
Note: The sensor's firmware version is in the footer of the sensor
web interface.
To Next Page
Loading...
