FLIR BRICKSTREAM 3D Gen 2 - Setting the Device Manager Server

Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
64
7. To enable encryption of the logging data stream:
a. Click the Encryption switch to ON.
b. In the SNI Host Name field, enter the Server Name Indication (SNI) for the host.
8. Click Test Settings to test the connection of the logger server. A logger request is immediately
sent to the IP address and port specified. A success or failure message is displayed at the top of
the page.
9. Click Save.
Setting the Device Manager Server
You can point the Brickstream sensor to the Device Manager Server.
Device Manager settings can be done on the Basic Settings page or in the Configuration Wizard.
1. On the Settings>Basic Settings page, click the Device Manager tab.
2. Click the Enabled switch to ON. The fields become active.
3. In the IP or Host Name field, enter the IP address or host name where the Device Manager Server
is running.
4. In the Port Number field, enter the port number used for the Device Manager Server (may be
provided by your Network Administrator).
5. In the APIToken field, enter the token. An API token is a cryptic string of up to 255 characters,
used to authenticate access to the HTTPS server.
6. To enable encryption, click the Encryption switch to ON and enter the SNIHost Name. An
encrypted connection to the Device Manager is supported on Device Manager version 5.0 or later.
7. In the Connect Frequency field, enter the frequency (in milliseconds) that the sensor checks the
Device Manager Server for connection requests. The default value is 10000.