Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
112
Components
Lenses
Specification Monochrome Lenses
Function Behavior analytics
Quantity 2
Focal Length Options
2.5 mm
6.0 mm
Image Sensor
752 x 480 pixels
Wide VGA
High Dynamic Range (HDR)
Resolution 0.4 megapixels
Video Compression None
Typical minimum operating light level 2 Lux
LED Functionality
This section provides a detailed explanation of the LED light functions on the 3D Gen 2 sensor.
LED lights may turn off after booting up if configured to do so in Defining the Device Identification .
Status
LED
Illumination Indication
1
Blinking amber at
three-second
intervals
Connected with neither the time sync server nor the data server
Blinking green at
three-second
intervals
Connected to time sync and/or data servers
2
Red Operating with factory-default IP address (192.168.1.7)
Progressive
Indicates whether the sensor has reverted back to its default factory
settings and is also used with the manual reset button. See Resetting the
Sensor.
Note: Contact Brickstream Support if you see a different
LEDcombination than what is documented.
To Next Page
Loading...
