Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
45
Step 3 of 10—User Management
The web interface can be password protected to prevent unauthorized users from accessing the sensor.
When enabled, the web interface prompts users for a username and password before allowing them to
view any of the sensor's web pages. By default, password protection is disabled.
The user defined in the Configuration Wizard is an administrator who has access to all the features of
the sensor. An operator user with access limited to daily tasks or maintenance of the sensor, and a
viewer user with access limited to the occupancy dashboard, can be created on the Basic Settings -
Web Server tab. See Setting the Web Server Information.
1. Click the Enabled switch to ON.
The fields become active.
2. In the Username field, enter a username.
Note: Both Username and Password fields are case
sensitive.
3. In the Password field, enter a password. Passwords can be up to 16 characters. Valid characters
are 0-1, A-Z, a-z, and any of the following special characters:
@!#$%'()*+,-./:;|=^~?_
4. In the Re-Enter Password field, re-enter the password.
5. Click Save & Next. You are then prompted to enter the name and password for authentication.
Note: This information is also on the Settings->Basic Settings
page, Web Server tab.
To Next Page
Loading...
