FLIR BRICKSTREAM 3D Gen 2 - Page 44

Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
44
Note: To use the Brickstream proprietary time sync
protocol you must use Device Manager to provide the
time sync. The time synchronization port and data delivery
port can be sent to the same IP address and port if
necessary, except when opting for either daytime or SNTP
protocol.
5. Click Sync Now to test the connection of the time sync server. A time sync request is
immediately sent to the IP address and port specified. A success or failure message is displayed
at the top of the page depending on the synchronization outcome.
6. Alternatively, you can set the date and time manually and click Set Time.
7. Click Save &Next.
Note: This information is also on the Settings->Basic Settings
page, Date and Time tab.