FLIR BRICKSTREAM 3D Gen 2 - Setting the Date and Time; Automatic Time Synchronization

Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
61
Note: Password fields intentionally appear blank for saved users.
Setting the Date and Time
The date and time of the sensor can be set automatically through the time server or manually through
the web interface. FLIR recommends using a time server as a manual setting is subject to drift and can
become inaccurate.
Note: The sensor does not have an internal clock and so does
not increment time when powered off.
When the sensor starts up it attempts a time sync with the time server. If a sync is not possible, the
sensor reverts to the last known time until the next successful sync. If the sensor was shut down due to
loss of power, the last known time may be inaccurate. If automatic time syncing fails, a manual time
setting is necessary.
Setting the date and time can be done on the Basic Settings page or in the Configuration Wizard.
Automatic Time Synchronization
1. On the Settings>Basic Settings page, click the Date &Time tab.
2. From the Time Server Protocol drop-down, select an appropriate protocol.