Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
115
1. Insert a paper clip into the reset button on the 3D Gen 2 sensor and depress the button until the
desired color illuminates on LED 2, then release the button. Use the following chart to determine
how long to hold in the reset button.
Note: LED 2 shows a sequence of colors depending on
how long you depress the Reset button.
Function 3 Seconds 6 Seconds 12 Seconds
LED Color Green Amber
Green/
Amber
Reset IP address to 192.168.1.7 X X
Restore factory default settings X
Delete configured zones X
Reset licensing X
Reset all privacy options X X
2. The desired LED color illuminates and stays lit for 10 seconds, during which time you must press
and release the Reset button again to confirm the action. After confirming the action, the sensor
executes the action and reboots the sensor.
Note: If the firmware is corrupted and your sensor constantly
reboots, unplug the sensor, press and hold the reset button
while plugging in the sensor, and then complete the reset steps.
Note: Contact Brickstream Support if you see a different
LEDcombination than what is documented.
To Next Page
Loading...
