FLIR BRICKSTREAM 3D Gen 2

To Next Page

To Previous Page

Brickstream® 3D Gen 2 Version 6.2

6/25/2021

Imaging Solutions Inc.

Brickstream® 3D Gen 2 Installation Guide

June 2021

5. Placement of ceiling fixtures and other objects suspended from the ceiling can affect sensor

coverage ares. Take the following into account when considering the impact of a site’s ceiling

fixtures on the requirements for sensors:

n Identify all ceiling fixtures such as lighting, signage, and HVAC equipment that are

attached to the ceiling in the area where the sensor will be installed.

n Ask for a Reflective Ceiling Plan (RCP) if possible.

n It is critical to know how far ceiling fixtures hang down from the ceiling and the exact

locations.

6. Take photos of door, ceiling, queue, service, and head-end, as well as referential photos to

improve usefulness, zoomed out to ensure that both floor and ceiling can be seen in the photo.

n Low-resolution setting is optimal (800 x 600) to avoid photos with large file sizes.

n Photograph the same subject from multiple angles — front, side, and angled views.

n Only take close-up photos of specific elements where detail is required (outlets, network

switches, etc.) and include a zoomed-out view as well.

7. Use a standardized site survey document to ensure all necessary data is collected and retained.

FLIR BRICKSTREAM 3D Gen 2 - Page 28