FLIR BRICKSTREAM 3D Gen 2 - Page 66

Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
66
register the sensor to a site. Please consult the Device Manager documentation, or contact support for
assistance.
Note: These settings are also available through the Configuration
Wizard.
There is a Reset link that returns you to the last saved settings. You may have to refresh the page.
1. Open the web interface to the Settings> Device Identification page.
2. Enter the following information:
a. Site ID—classification for a store or site number.
b. Site Name—classification for a store or site name.
c. Division ID—classification to identify this sensor within a group of locations.
d. Sensor ID—an alphanumeric code to uniquely identify the sensor within a site.
e. Sensor Name—a brief name for the sensor.
3. From the LEDStatus Lights drop-down, select if you want LED lights to be always on, or to turn
off after a defined time following a reboot. If a time is selected, the LEDlights are on during the
reboot to verify the startup sequence and then turn off once the selected time has passed.
4. From the XMLData Format drop-down, select a format to use for output data. The default (and
recommended) selection is Latest. More detailed information about XML formats can be found in
the Programmer's Guide.
5. Click Save.