Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
81
Note: If traffic map delivery is disabled, no traffic map data
is delivered to the Floorplan Editor or to the Traffic Map
Analysis web tool.
3. In the IP Or Host Name field, enter the IP address of the server to receive data from the sensor.
4. In the Port Number field, enter the port number to which the sensor should attempt to deliver
data.
5. In the Destination URL/directory field, enter the URL if the sensor needs to send data to a specific
URL in the HTTP POST.
Note: Use ‘/’ if you have not been directed to change this
field. This allows your IT department to use the same port
for multiple sensors and filter the traffic by the URL in the
HTTP POST.
6. From the Delivery Schedule drop-down, select how frequently to deliver the data.
The delivery schedule can be either hourly or daily. The sensor attempts to send the previous
hour's data approximately on the hour or the previous day's data at midnight. The start time to
send is randomized so not all sensors send at the same time. A sensor makes up to 3 attempts to
send the data over 15 to 20 minutes. After a successful send, or after three failed attempts, the
sensor deletes that batch of data. Once deleted the data cannot be recovered.
To Next Page
Loading...
