FLIR BRICKSTREAM 3D Gen 2 - Page 85

Brickstream® 3D Gen 2 Version 6.2
6/25/2021
©2016-2021 FLIR Integrated
Imaging Solutions Inc.
All rights reserved.
Brickstream® 3D Gen 2 Installation Guide
June 2021
85
1. Open the web interface to the Data Delivery> Tailgating page.
2. Click the Enable Delivery switch to ON.
The fields become active.
3. In the IPor Host Name field, enter the IP address of the server to receive data feeds from the
sensor.
4. In the Port Number field, enter the port number to which the sensor should attempt to deliver
data feeds.
5. If the sensor needs to send data feeds to a specific URL address in the HTTP POST, in the
Destination URL/directory field enter the URL address.
Note: Use ‘/’ if you have not been directed to change this
field. This allows your IT department to use the same port
for multiple sensors and filter the traffic by the URL in the
HTTP POST.
6. In the APIToken field, enter the token. An API token is a cryptic string of up to 255 characters,
used to authenticate access to the HTTPS server.
7. If you want the batch data stream to be encrypted:
a. Click the Data Encryption switch to ON.
b. In the SNI Host Name field, enter the Server Name Indication (SNI) hostname or IP address
for the host.