Fluke DTX Series - Page 247

Index
(continued)
5
—P—
PASS*, 3-12
patch cord
replacement, 9-7
testing, 5-8
Patch Lengths, 5-13
permanent link
interface adapters, 1-18
test connections, 3-7
personality module, 1-20
power
powering the tester, 1-14
specifications, 9-32
power down timer, 1-25
power meter, 5-46
measurement is too high or too
low, 7-4
problems
fiber cabling, 7-1
twisted pair cabling, 4-2
with the tester, 9-7
propagation delay
diagnosing failures, 4-8
specifications, 9-17
test in Smart Remote mode, 5-21,
5-29
test on twisted pair, 3-17
PSACR test, 3-26
PSELFEXT
diagnosing failures, 4-4
test, 3-29
PSNEXT
diagnosing failures, 4-4
test, 3-26
—R—
referencing
fiber
alternate connections, B-8
Far End Source mode, 5-32
Loopback mode, 5-24
Smart Remote mode, 5-16
when to set, 5-6
twisted pair, 3-1
registration, 1-2
Remote End Setup, 5-9
resistance
diagnosing failures, 4-7
specifications, 9-17
test, 3-15
Result Storage Location, 1-27, 2-4, 8-3
return loss
diagnosing failures, 4-5
HDTDR analyzer, 4-12
specifications, 9-20
test, 3-24
RJ11 connector, 1-7
—S—
safety
information, 1-6
standards, 9-33
safety information, 5-1
self test
fiber modules, 5-4
twisted pair adapters, 1-21
sequential cable IDs, 2-21
serial cable (RS-232), 9-3
serial port, 9-34
service, 9-7
Set Reference
fiber, 5-13
twisted pair, 3-5
settings
fiber, 5-9
twisted pair, 3-3
user preferences, 1-24
setup
battery, 1-14
fiber settings, 5-9
language, 1-14